Oil Tank Water Removal Automatic water cutting device

The water settling at the bottom of the oil tank enters the water cutter. Two oil and water detectors and one controller are installed on each intelligent water cutter. When the commissioning detector of the water cutter detects that the oil content in the water is lower than the set amount, the field controller outputs the command to open the water cutting valve and start cutting water; When this detection controller detects that the oil in the water exceeds the set amount, the cut valve is closed. In the closed valve state, because of steam heating, the temperature of the medium in the water cutter continues to rise, and the oil entering the water cutter is easier to return to the oil tank in the high temperature state. (When installed on light oil tanks, no heating is required.) The medium in the water cutter is automatically stratified by sedimentation, the upper oil is replaced by the water in the oil tank, and the water level in the water cutter gradually rises. When the detector detects that the oil content in the water is lower than the set amount again, the valve is opened and the water cutter starts to cut again.Filtering Equipment Reciprocating operation, when the water cutting is finished, there is still some water at the bottom of the water cutting device that is not released, forming a "water seal" to ensure zero oil discharge and ensure the safety of water cutting. In addition, the front stage of the water valve adopts a single electronically controlled, single-acting pneumatic valve, which will close the valve in the case of power failure and gas shutdown.

The working condition of the intelligent water cutter is transmitted to the monitoring computer in real time, and the working condition of each intelligent water cutter can be observed in the operation room.

Oil Tank Water Removal Automatic water cutting device The explosion-proof level of the site monitor used meets the national standard and ADAPTS to the explosion-proof requirements of the site environment.

Perfect management system: Through the special monitoring management software, the working condition of multiple water cutters can be monitored on the computer.

The main technical parameters of HQS-Z intelligent water cutter

1, power supply voltage: 24VDC/30W, built-in EMI filter.

2, heating steam pressure: 0.1Mpa ~ 1.0Mpa.

3, explosion-proof mark: EX d II BT4.

4, output: a, valve control signal: switch signal;

b, communication signal: RS-485;

c, on-site display: Chinese LCD (wide temperature).

(a) Adjustment mode: a, on-site adjustment with microcomputer;

b, key adjustment;

c, handheld infrared remote control adjustment;

d, remote adjustment by means of communication.

6. Reaction time: <3 seconds.

7, working mode: online 24/7 continuous operation.

8, cutting water capacity: 5 ~ 60 tons/hour.

9, cut water oil content: light oil ≤100ppm, heavy oil ≤200ppm.

10, ambient temperature: -40℃ ~ 80℃.